STRAIGHT TEE FITTING

Central vacuum elbow & fitting, used as coupler for central vacuum whole house systems. Spigot Fittings have one female and one male end they can be used to shift pipe gradually either horizontally or vertically in conjuction with another fitting to change pipe direction and move up or down. Use of two 45° fittings is better than two 90° fittings from a performance standpoint.

Used in place of Sweep 90° Elbow when a tighter turn is required. Use of Medium 90° Elbows should be minimized to optimize system performance.

Used to turn pipe 90°. This is often called a wide 90 and the most common elbow used in the system. Can be doubled up to create a (S) type configuration so dirt does not fall into inlets at lower lever than the tank. One male end - one female end

Used to connect pipes coming together at 45° angle. Most often used where a pipe from 2nd. floor joins into wertical drop.

Straight tee couplers are used for setting a inlet on both sides of a wall, or making a drop straight from the 2nd. floor to the 1st. floor

Pipe straps secure pipe to joist and should be placed at least every 3 feet on trunk line.

Exhaust Mufflers reduce exhaust noise and can be used on all power units even if these are not vented to the outsidde

Use with low voltage (NON SUPERVALVE) inlets. Fits in 2" x 4" walls and larger. Works with new and existing construction. Central Vac installation fittings (installation componets) are known by many names, Some of which include Fittings, Elbows, Couplers, We carry are parts neccessary to pipe and complete your system. Central Vac Elbows, Low Voltage Wire, Central Vacuum Pipe, Exhaust Covers and Power Units.

Central Vac installation fittings (installation componets) are known by many names, Some of which include Fittings, Elbows, Couplers, We carry are parts neccessary to pipe and complete your system. Central Vac Elbows, Low Voltage Wire, Central Vacuum Pipe, Exhaust Covers and Power Units.